Tips for daily maintenance of bimetal barrel screw Bimetallic barrel screw daily maintenance tips: 1. Never start the machine when the barrel screw has not reached the preset temperature. 2. Prevent metal fragments and debris from falling into the hopper. If processing recycled materials, it is necessary to add a magnetic hopper to prevent iron chips from entering the barrel. 3
Why does the extruder barrel screw produce noise? In the process of extrusion processing, the screw of the extruder will make a noise when it rubs against the inner wall of the barrel.The reasons for this friction phenomenon are: 1. The assembly gap between the barrel screw of the rubber extruder and the supporting transmission shaft is too large, and the center lines of the two shafts
Introduction of bimetallic screw production process The bimetallic screw and barrel bimetallic process is a more commonly used process combination product with excellent corrosion resistance and wear resistance in recent years. The HVOF high-speed spraying equipment is used to melt spray spray the surface of the screw to obtain a densely structured bimetallic Screw; the bimetallic barrel adopts
Routine maintenance of screw barrel of extruder Daily maintenance of screw barrel of extruder: 1. Never start the machine when the barrel screw has not reached the preset temperature. 2. Prevent metal fragments and debris from falling into the hopper. If processing recycled materials, a magnetic hopper should be added to prevent iron scraps from entering the barrel. 3. Make sure
What is the effect of excessive clearance between screw and barrel? Influence of excessive gap between screw and barrel: 1. The gap between the screw and the barrel is too large, and the flow rate of the molten material during extrusion is unstable, and the product surface is prone to horizontal wrinkles. 2. The gap is too large, the extrusion melt pressure is unstable, so that the c
What are the types of screw gaps of conical twin-screw extruders and what are their functions? In summary, there are the following four working gaps between the screw and barrel of the conical twin screw extruder: (1) The radial clearance between the end surface of the screw rib and the inner diameter circumference of the barrel. (2) The radial clearance between the end surface of the scr
Common problems Possible cause Solution There are bumps on the wall of the tube (like bubbles). The moisture of the material is too high. Properly increase the mixing temperature and extend the mixing time. Impurities mixed in the material Check the source of impurities and remove impurities Poor plasticization. Reduce external lubricant in an appropriate amount and increase plasticization.
The conical twin-screw extruder is the main equipment for producing plastic profiles. When the profile is produced, the twin screw rotates outward in the barrel in different directions. The size of the screw gap not only affects the plasticizing effect of the material, but also affects the quality of the product, sometimes causing machine failure, and even leading to scrapping of heart parts such
